Removing The Hopper Unit - Canon imagePRESS C1 P Service Manual

Chapter 10
6) Remove one hopper right fixing screw [1].
[1]
7) Remove one hopper left fixing screw [1].
8) Pull the hopper unit [1] up in the direction of the arrow until it hits.
10-18
[2] [1]
F-10-46
[1]
F-10-47
[1]
[1]
F-10-48
Points to Note When Lifting Up the Hopper Unit
- In case the copyboard cover is attached, make sure to open it prior to lifting
up the hopper unit to prevent any damages caused by contact.
- Check if the lock arm [1] at the left-lower to the hopper is hooked by the
shaft [2] and the hopper unit is locked.
[2]
[1]

10.5.2.4 Removing the Hopper Unit

imagePRESS C1 P / imagePRESS C1
1) Pull the hopper unit shutter lever [1] forward to the end.
[1]
F-10-49
F-10-50
0014-0578