Canon imageRUNNER ADVANCE C5255 Series Service Manual page 245

2
Technology > Embedded RDS > E-RDS Setup > Steps to E-RDS settings
■ Steps to E-RDS settings
1. Start [Service Mode] at Level 1.
2. Select [COPIER] > [Function] > [CLEAR] > [ERDS-DAT] and touch the [OK] button.
NOTE:
This operation initializes the E-RDS settings to factory setting values.
For the setting values to be initialized, see the section of "Initializing E-RDS settings".
3. Perform installation or deletion of the CA certificate if necessary, and reboot this machine.
• Installation of the CA certificate: Perform installation from SST or Remote UI.
• Deletion of the CA certificate: When the following operation is performed, the CA certificate
in the factory setting is automatically installed.
CAUTION:
After following procedure, the registered key and CA certificate are deleted, and only
the CA certificate installed at the time of shipment is registered.
It is therefore necessary to check with the user in advance.
(1) Start [Service Mode] at Level 2.
2 Technology > Embedded RDS > E-RDS Setup > Steps to E-RDS settings
(2) Select [COPIER] > [Function] > [CLEAR] > [CA-KEY] and touch the [OK] button.
"OK!" is displayed if the CA certificate is initialized. When "NG!" is displayed, see the
section of "Troubleshooting" to execute the remedy, and then perform initialization of the
CA certificate again and check to see if the CA certificate is initialized.
F-2-373
(3) Reboot this machine.
CAUTION:
If a key and a CA certificate have been registered in order to use a function other than
E-RDS, it is necessary to register again from SST or Remote UI.
2-207
F-2-374
F-2-375
2-207