Setting The Method To Login To Sms - Canon imageRUNNER ADVANCE C5255 Series Service Manual

2
Technology > MEAP > Setting the method to login to SMS > Outline

Setting the method to login to SMS

■ Outline
The method to log into SMS can be specified by one of the following methods.
• If you want to change the password authentication settings: Use RLS authentication
to log in, and change the settings.
• If you want to change the RLS authentication settings: Use password authentication
to log in, and change the settings.
The following table shows the start/stop combinations of the two login methods.
Combination of Login Methods
Start RLS Authentication
Start Password Authentication Login available with either method
Stop Password Authentication Login available only with RLS
Authentication
CAUTION:
If only login via RLS is programmed, login may be disabled for the following reasons.
• Authentication server is down
• Network problem, no communication with authentication server
In the event of either of these cases, try the following.
1. If local device authentication is active, try logging in with local device
authentication.
2. If only server authentication is active, launch in MEAP safe mode from the device
service mode.
After launching in MEAP safe mode, the Default Authentication will become active, and
you will be able to login to SMS with password authentication. After logging into SMS,
set the password authentication login to ON (active) and restore the device from MEAP
safe mode to normal mode. Until the problem blocking authentication is resolved, log
into SMS with password authentication.
2 Technology > MEAP > Setting the method to login to SMS > Outline
● Setting for login by Password Authentication
The procedures for changing the password authentication Start/ stop settings are as follows.
1) Access SMS login screen by RLS Authentication from the PC browser on the same network
as the MEAP device.
URL: https://<IP address of MEAP device>:8443/sms/rls/
Ex.) https://172.16.188.240:8443/sms/rls
2) Enter the user name and the password of the user registered as an administrator, select
the login destination, and then click the [Log In] button.
Login screen (In case authentication method is SSO-H)
Stop RLS Authentication
Login available only with
Setting unavailable
T-2-89
3) Select [System Application Management]
2-164
F-2-268
F-2-269
2-164