4
Parts Replacement and Cleaning > Image Formation System > Removing the ITB > Procedure
7) Pull out the front pin.
NOTE:
To lock the pressure, pull out the pin while holding the ITB Unit with hand.
• 1 screw
8) Bend the Secondary Transfer Inner Roller Unit by 90 degree and reinstall it with the pin
removed in step 7).
4
Parts Replacement and Cleaning > Image Formation System > Removing the ITB > Procedure
F-4-146
F-4-147
9) Insert papers as shown in the figure to prevent the ITB getting damage by the plate when
removing the ITB.
10) Hold the ITB within 10mm from the edge and remove it upward.
4-115
F-4-148
10mm
10mm
F-4-149
4-115