MX104 3D Universal Edge Router Hardware Guide
Connecting the Router to a Management Console Device
60
Figure 20: Ethernet Port
MGMT
port
You can connect a console, laptop, modem, or other auxiliary device by connecting a
serial cable to the port on the front panel labeled
cable with an RJ-45 connector that is provided with the router.
NOTE:
The
AUX
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Plug the RJ-45 end of the serial cable into the
2.
(Figure 21 on page 60
shows the connector.
Plug the female DB-9 end into the serial port of the device.
3.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 21: Routing Engine Console Cable Connector
Figure 22: Console Connections
CONSOLE/AUX
port
Management PC
Management
network
CONSOLE
port is not supported.
CONSOLE
Figure 22 on page 60
Console Server
. This port accepts a serial
port on the Routing Engine
shows the ports.)
PC
Copyright © 2014, Juniper Networks, Inc.