Unpacking And Mounting The Acx1000 And Acx1100 Routers; Unpacking An Acx1000 Or Acx1100 Router - Juniper ACX1000 Hardware Manual

Unpacking and Mounting the ACX1000 and
ACX1100 Routers
IN THIS SECTION

Unpacking an ACX1000 or ACX1100 Router | 94

Parts Inventory (Packing List) for an ACX1000 and ACX1100 Router | 95
Installing the ACX1000 or ACX1100 Mounting Brackets | 96
Installing the ACX1000 or ACX1100 Router in the Rack | 97
Unpacking an ACX1000 or ACX1100 Router
The ACX1000 and ACX1100 routers are shipped in a cardboard carton, secured with foam packing
material. The carton also contains an accessory box.
CAUTION: ACX1000 and ACX1100 routers are maximally protected inside the shipping
carton. Do not unpack the routers until you are ready to begin installation.
To unpack the router and prepare for installation, you need the following tools:
• Blank panels to cover any slots not occupied by a component
To unpack the router:
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory box, and verify the contents in it against the parts inventory on the label
attached to the carton.
5. Pull out the packing material holding the router in place.
6. Verify the chassis components received against the packing list included with the router. An
inventory of parts provided with the router is provided in
ACX1000 and ACX1100 Router" on page
"Parts Inventory (Packing List) for an
95.
94