Unpacking And Mounting The Acx4000 Router; Unpacking An Acx4000 Router - Juniper ACX4000 Hardware Manual

Unpacking and Mounting the ACX4000 Router

IN THIS SECTION

Unpacking an ACX4000 Router | 95

Parts Inventory (Packing List) for an ACX4000 Router | 96
Installing the ACX4000 Mounting Brackets | 97
Installing the ACX4000 Router in the Rack | 98
Unpacking an ACX4000 Router
The ACX4000 routers are shipped in a cardboard carton, secured with foam packing material. The
carton also contains an accessory box.
CAUTION: ACX4000 routers are maximally protected inside the shipping carton. Do
not unpack the routers until you are ready to begin installation.
To unpack the router and prepare for installation, you need the following tools:
• Blank panels to cover any slots not occupied by a component
To unpack the router:
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory box and verify the contents in it against the parts inventory on the label
attached to the carton.
5. Pull out the packing material holding the router in place.
6. Verify the chassis components received against the packing list included with the router. An
inventory of parts provided with the router is provided in
ACX4000 Router" on page
7. Save the shipping carton and packing materials in case you need to move or ship the router later.
96.
"Parts Inventory (Packing List) for an
95