Creating A Control Program - Agilent Technologies Agilent E5250A User Manual

CAUTION
Programming the E5250A

Creating a Control Program

Creating a Control Program
This section explains how to create a control program for the E5250A.
The control program basically consists of the following six parts:
• "Defining Channel Configuration Mode"
• "Defining Connection Rule"
• "Defining Connection Sequence"
• "Using Bias Mode"
• "Using Couple Port (for E5252A only)"
• "Controlling Relay Switching"
Table 6-1 summarizes the commands for each part of the control program for the
E5250A. In the table, default setting means the instrument state by the *RST
command or power on.
The SCPI commands introduced in this section are ROUTe subsystem commands
for controlling the E5250A.
There are also other SCPI subsystem commands for the E5250A: DIAGnostic and
SYSTem subsystem commands. For details about all SCPI commands, refer to
Chapter 7.
6-6 Agilent E5250A User's Guide, Edition 11