Agilent Technologies Agilent E5250A User Manual page 194

Syntax
Query response
Example
Command Reference
[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]?
[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]?
This query command returns 0 or 1 for each channel specified by channel_list, in
same order as specified by channel_list.
0: channel is bias disabled, 1: channel is bias enabled.
[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]? (@channel_list)
Parameter
channel_list
The input ports specified by the channel_list are ignored. The input port is always
the input Bias Port. So, in the channel_list, only the card numbers and output ports
have meaning. But you cannot omit the input port in the channel_list.
enable_status{,enable_status} <newline><^END>
1 : enabled
0 : disabled
OUTPUT @Hp5250;":ROUT:BIAS:CHAN:DIS:CARD ALL"
OUTPUT @Hp5250;":ROUT:BIAS:CHAN:ENAB (@10101)"
OUTPUT @Hp5250;":ROUT:BIAS:CHAN:ENAB? (@10101,10102,10201)"
ENTER @Hp5250;A$
In above example, A$ will be as follows:
1,0,1
10101 and 10201 have the same meaning because the specified input port is
ignored.
7-26
Explanation
Channels to check.
For details about channel_list, refer to Chapter 5.
Agilent E5250A User's Guide, Edition 11