NOTE
Syntax
Example
[:ROUTe]:COUPle[:STATe]
This command applies only to the E5252A card.
The Couple Port function is not available for the E5255A card.
This command controls the Couple Port Mode for the specified card. For details,
refer to "Couple Ports" in Chapter 5.
To set up the couple ports, refer to :ROUT:COUP:PORT.
At *RST, the value of this parameter is OFF.
[:ROUTe]:COUPle[:STATe] card_number,state
Parameter
card_number
state
OUTPUT @Hp5250;":ROUT:COUP:STAT ALL,ON"
Agilent E5250A User's Guide, Edition 11
Explanation
card number:
For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
ON or 1: turn ON the Couple Port Mode
OFF or 0: turn OFF the Couple Port Mode
Command Reference
[:ROUTe]:COUPle[:STATe]
7-37