Agilent Technologies Agilent E5250A User Manual page 208

Syntax
Example
Syntax
Example
Command Reference
[:ROUTe]:OPEN:CARD
[:ROUTe]:OPEN:CARD
This command disconnects all input ports from all output ports for the specified
card. Then, if Bias Mode is ON, connects the input Bias Port to all bias enabled
output ports.
For details about the Bias Mode, refer to ":ROUTe:BIAS:STATe" in this chapter and
refer to Chapter 5.
[:ROUTe]:OPEN:CARD card_number
Parameter
card_number
OUTPUT @Hp5250;":ROUT:OPEN:CARD ALL"
[:ROUTe]:OPEN[:LIST]
This command disconnects the input ports from output ports as specified in
channel_list.
For some modes (such as Single Route Mode, Couple Port Mode, and Bias Mode),
more complex disconnections may occur. For details, refer to Chapter 5.
For example, if Bias Mode is ON, you cannot directly specify the input Bias port.
But if you use :ROUT:OPEN to disconnect a bias enabled output port from another
input port, the output port is automatically connected to the input Bias Port.
[:ROUTe]:OPEN[:LIST] (@channel_list)
Parameter
channel_list
OUTPUT @Hp5250;":ROUT:OPEN (@10101,10202)"
7-40
Explanation
card number:
For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Explanation
Channels to open (disconnect).
For details about channel_list, refer to Chapter 5.
Agilent E5250A User's Guide, Edition 11