Agilent Technologies Agilent E5250A User Manual page 266

Figure 9-2
Executing Sample Programs
Vth and Capacitance Measurement Program
Execute the program as follows:
1. LOAD the Vth and C measurement program as following example.
LOAD "P_MAT"
2. Link the Capacitance Compensation Routine by using the LOADSUB ALL
statement as in following example.
LOADSUB ALL FROM "C_COM"
3. Eject the E5250A Program Disk from the disk drive connected to the computer.
4. Insert the E5250A Program Disk into the 4155/4156's disk drive. Setup file
E5252.MES is stored on the disk and is used to set up 4155/4156 for the Vth
measurement.
5. RUN the program.
6. After the measurement, measurement results are displayed on the computer as
shown in example in Figure 9-2.
Example of Vth and C Measurement Results
Comment : Vth & C Meas. Sample Program
Test Time : 30 Sep 1995 10:29:27
# P/F Min.
1 P 10.000E-002 18.255E-001 20.000E-001 MOSFET Vth Measurement
2 F 8.000E-12
9-10
Meas. Max.
2.164E-11 2.000E-11
Agilent E5250A User's Guide, Edition 11
Comment
Capacitance Measurement