Agilent Technologies Agilent E5250A User Manual page 192

Syntax
Example
Command Reference
[:ROUTe]:BIAS:CHANnel:ENABle:CARD
[:ROUTe]:BIAS:CHANnel:ENABle:CARD
This command bias enables all output ports of the specified card.
When Bias Mode is ON, this command closes relays to connect the input Bias Port
to all output ports that are not already connected (by :ROUT:CLOS command) to
other input ports.
Refer to "ROUTe:BIAS:STATe".
At *RST, all output ports are bias enabled.
[:ROUTe]:BIAS:CHANnel:ENABle:CARD card_number
Parameter
card_number
OUTPUT @Hp5250;":ROUT:BIAS:CHAN:ENAB:CARD ALL"
7-24
Explanation
card number:
For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Agilent E5250A User's Guide, Edition 11