Checking The Damper - Husqvarna FE 450 2016 Repair Manual

9.18

Checking the damper

9 SHOCK ABSORBER, SWINGARM
-
Lubricate the special tool.
Shock absorber fluid (SAE 2.5) (50180751 S1)
Calibrating unit (T1205)
-
Support seal ring retainer @} with sleeve
tool.
I
Mounting tool (T150S)
-
Press the special tool through the new pilot bushing.
I
Calibrating unit (T1205)
200798-10
✓ The pilot bushing is calibrated.
Finishing work
-
Assemble the seal ring retainer.
Condition
The damper has been disassembled.
-
Measure the inside diameter on both ends and in the middle
of the damper cartridge.
Damper cartridge
Diameter
If the measured value is greater than the specified value:
-
Change the damper cartridge.
-
Check the damper cartridge for damage and wear.
If there is damage or wear:
201402-10 -
Change the damper cartridge.
-
Check the heim joint for damage and wear.
If there is damage or wear:
-
Change the heim joint.
-
Measure the diameter of the piston rod.
Piston rod
Diameter
If the measured value is less than the specified value:
-
Change the piston rod.
-
Measure the run-out of the piston rod.
Piston rod
I
Run-out
201403-10
If the measured value is greater than the specified value:
-
Change the piston rod.
-
Check the piston rod for damage and wear.
If there is damage or wear:
-
Change the piston rod.
(!!l p. 349)
(l!,JI p. 365)
of the special
f)
(l!,JI p. 368)
(l!,JI p. 365)
(l!,JI p. 67)
:5 50.08 mm (:5 1 .9716 in)
;;,: 17.95 mm(<:: 0.7067 in)
I
:5 0.02 mm (:5 0.0008 in)
65