Changing The Rear Brake Disc - Husqvarna FE 450 2016 Repair Manual

14 WHEELS
14.8.3
128

Changing the rear brake disc

Info
If the brake discs are changed, the brake linings must also be changed.
(FE 501 SUS)
-
Clean and grease the wheel spindle.
I
Long-life grease (a
-
Position the rear wheel and insert wheel spindle
-
Mount the chain.
✓ The brake linings are correctly positioned.
-
Position chain adjuster @) . Mount nut
tighten it yet.
-
Make sure that chain adjusters @) are fitted correctly on
0.
adjusting screws
-
Check the chain tension.
8.
-
Tighten nut
Guideline
Nut, rear wheel
spindle
• Info
I
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary
ratios with the same chain length.
Chain adjusters
-
Operate the foot brake lever repeatedly until the brake
linings are in contact with the brake disc and there is a
pressure point.
Finishing work
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the rear wheel. (�
Main work
(FE EU/AU, FE 450/501 US)
O.
-
Remove screws
-
Clean the contact surface of the brake disc.
-
Position the new brake disc with the label facing outward.
-
Mount and tighten screws
Guideline
Screw, rear M6
brake disc
p. 350)
8.
8,
but do not
(a p. 129)
M20x1 .5 80 Nm (59 lbf ft)
8
°
can be turned by 180
(� p. 14)
(� p. 14)
p. 125)
Remove the brake disc.
0-
14 Nm (10.3 lbf ft)
Loctite
.
®
243
™