23 Cylinder Head; Checking The Valve Clearance - Husqvarna FE 450 2016 Repair Manual

23 CYLINDER HEAD

23.1
266

Checking the valve clearance

Preparatory work
(FE EU/AU, FE 450/501 US)
-
Raise the motorcycle with a lift stand.
-
Remove the seat. (a
-
Remove the fuel tank.
(FE 501 SUS)
-
Raise the motorcycle with a lift stand.
-
Remove the seat. (a
-
Remove the fuel tank.
-
Remove the activated charcoal filter.
Main work
-
Disconnect spark plug connector
-
Remove the spark plug using the special tool.
I Spark plug wrench with link (77229172000)
8.
-
Push back hose clamp
-
Pull off the air release hose.
8.
-
Remove screws
-
Remove the valve cover with the gasket.
(FE EU/AU, FE 450/501 US)
-
Engage the highest gear.
-
Turn the rear wheel until the engine is at ignition top dead
center.
f)
✓ The markings
cylinder head are lined up with each other.
Info
Make sure that the crankshaft is at top dead cen­
ter.
(a p. 14)
p. 98)
(0 p. 99)
(a p. 14)
p. 98)
(0 p. 99)
(!!JI p. 110)
O.
(l!!JI p. 361)
on the camshaft and G) of the