Removing The Timing Chain Sprocket; Installing The Timing Chain Sprocket - Husqvarna FE 450 2016 Repair Manual

18 ENGINE
18.4.10
18.4.11
•
I
chain sprocket.
204
304714-10
309244-11
309243-11

Removing the timing chain sprocket

==-E---------' 304702-10

Installing the timing chain sprocket

Info
Never clamp the crankshaft with a crankshaft journal in the bench vise and try to hammer on the timing
In such a case, the crank webs will be distorted rendering the crankshaft unserviceable.
- (D
Mount special tool on the water pump shaft.
I Protection cap (90129005000)
C,.
-
Mount balancer shaft
• Info
I
Be careful not to damage the shaft seal rings.
-
Remove the special tool.
I Protection cap (90129005000)
-
Mount water pump impeller
-
Mount and tighten nut (D.
Guideline
Nut, water M6
pump impeller
-
Warm up the timing chain sprocket
-
Pull off the timing chain sprocket with the special tool.
I Puller (60029033000) (I!!,!
• Info
I
The timing chain sprocket is usually damaged by the
disassembly and must be replaced.
(I!!,! p. 363)
(I!!,! p. 363)
0-
8 Nm (5.9 lbf ft)
®
Loctite
O
with a blow-dryer.
p. 357)
..
243
™
<I