Checking The Damper - Husqvarna FC 450 2018 Repair Manual

Checkin the damper
9.18
SHOCK ABSORBER, LINK FORK 9
-
Slide the new pilot bushing
I
Pressing tool (T1504)
Position the pilot bushing in the seal ring retainer using the
special tool.
I
Pressing tool (T1504)
-
Support seal ring retainer @ with sleeve
tool. Press the pilot bushing all the way in.
I
Mounting tool (T150S)
-
Lubricate the special tool.
Shock absorber fluid (SAE 2.5) (50180751 S1)
Calibrating unit (T1205)
-
Support seal ring retainer @ with sleeve
tool.
I
Mounting tool (T150S)
-
Press the special tool through the new pilot bushing.
I
200798-10
Calibrating unit (T1205)
✓ The pilot bushing is calibrated.
Finishing work
-
Assemble the seal ring retainer.
Condition
The damper has been disassembled.
-
Measure the inside diameter on both ends and in the middle
of the damper cartridge.
Damper cartridge
Diameter
If the measured value is greater than the specified value:
-
Change the damper cartridge.
-
Check the damper cartridge for damage and wear.
If there is damage or wear:
B04408-10
-
Change the damper cartridge.
-
Check the heim joint for damage and wear.
If there is damage or wear:
-
Change the heim joint.
O
onto the special tool.
(8 p. 324)
(0 p. 324)
6)
of the special
(8 p. 324)
(8 p. 303)
(8 p. 320)
6)
of the special
(0 p. 324)
(8 p. 320)
(8 p. 73)
� 50.08 mm (� 1 .9716 in)
...
71