(FE 501 SUS)
-
Engage the highest gear.
-
Turn the rear wheel until the engine is at ignition top dead
center.
f)
✓ The markings
cylinder head are lined up with each other.
Info
Make sure that the crankshaft is at top dead cen
ter.
-
Unscrew and remove screw
0.
-
Remove washer
Mount and tighten screw
Check the valve clearance at all valves between the valve
and rocker arm.
Guideline
Valve clearance
Exhaust at: 20 °C
(68 °F)
Intake at: 20 °C (68 °F)
I Feeler gauge (59029041100)
If the valve clearance does not meet specifications:
-
Adjust the valve clearance.
-
Remove locking screw
-
Crank the engine several times.
-
Check the valve clearance and correct it if necessary.
-
Mount and tighten screw
Guideline
Plug, crankshaft
location
23 CYLINDER HEAD
Cs)
on the camshaft and
of the
C,.
C,
without the washer.
0.12 ... 0.17 mm (0.0047
... 0.0067 in)
0.10 ... 0.15 mm (0.0039
... 0.0059 in)
(0
p. 357)
(0
p. 245)
C,.
C,
with washer@).
M8
10 Nm (7.4 lbf ft)
267