Husqvarna FE 450 2016 Repair Manual page 60

9 SHOCK ABSORBER, SWINGARM
-
Check needle bearings
-
Check spacers
-
Check the shaft seal rings for damage and wear.
58
@-
8
and
If there is damage or wear:
-
Change the needle bearings.
(D
and @ for damage and wear.
If there is damage or wear:
-
Change the spacers.
If there is damage or wear:
-
Change the shaft seal rings.
-@
@»
for damage and wear.
-
Check dimension f).
I 54.91 ... 55.00 mm (2.1618 ... 2.1654 in)
If dimension f) is below the specified value:
-
Add the necessary spacing washers
-
Position angle lever.
(D
-
Mount fitting
Guideline
Nut, angle lever on
swingarm
303096-10
@).
but do not tighten yet.
M14x1.5 80 Nm (59 lbf ft)