Husqvarna FE 450 2016 Repair Manual page 135

-
Check the chain sliding piece for wear.
If the lower edge of the chain pins is in line with or below
the chain sliding piece:
-
Change the chain sliding piece.
-
Check that the chain sliding piece is firmly seated.
If the chain sliding piece is loose:
-
Tighten the screw of the chain sliding piece.
Guideline
Screw, chain slid-
ing piece
-
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
If the light part of the chain guide is worn:
-
Change the chain guide.
(FE EU/ AU, FE 450/501 US)
-
Check that the chain guide is firmly seated.
If the chain guide is loose:
-
Tighten the fitting on the chain guide.
Guideline
Remaining
screws, chassis
Remaining nuts,
chassis
(FE 501 SUS)
-
Check that the chain guide is firmly seated.
If the chain guide is loose:
-
Tighten the fitting on the chain guide.
Guideline
Remaining
screws, chassis
Remaining nuts,
chassis
Finishing work
-
Remove the motorcycle from the lift stand.
14 WHEELS
M8 15 Nm
(11.1 lbf ft)
10 Nm
M6
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
(IOJ p. 14)
133