Installing The Battery; Recharging The Battery - Husqvarna FE 450 2016 Repair Manual

lnstallin the battery
-A
f - --0
___. e
Recharging the batte
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
-
Keep batteries out of the reach of children.
-
Wear suitable protective clothing and safety glasses.
-
Avoid contact with battery acid and battery gases.
-
Keep sparks or open flames away from the battery.
-
Only charge batteries in well-ventilated rooms.
-
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
-
Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Main work
-
Pull back the negative terminal cover
negative cable from the battery.
-
Pull back positive terminal cover @ and disconnect the pos­
itive cable from the battery.
-
Detach rubber band
-
Lift the battery up and out.
\
Main work
-
Insert the battery into the battery compartment with the ter­
minals facing forward.
I
Battery (YTXSL-BS)
-
Reconnect rubber band
Info
Contact disks
and cable sockets
tery terminal.
-
Position the positive cable and mount and tighten the screw.
Guideline
o
Screw, battery termi-
nal
-
Slide positive terminal cover @ over the positive terminal.
-
Position the negative cable and mount and tighten the screw.
Guideline
H00387-10
Screw, battery termi-
nal
-
Slide negative terminal cover
Finishing work
-
Mount the seat.
15 WIRING HARNESS, BATTERY
O
@)
at the bottom.
(a p. 278)
O.
6)
must be mounted under screws
0
with the claws toward the bat­
MS
MS
@)
over the negative terminal.
(� p. 98)
and disconnect the
41
8
2.5 Nm (1 .84 lbf ft)
2.5 Nm (1 .84 lbf ft)
145