Checking The Chain, Rear Sprocket, Engine Sprocket And Chain Guide - Husqvarna FE 450 2016 Repair Manual

14.8.6

Checking the chain, rear sprocket, engine sprocket and chain guide

..
(FE 501 SUS)
-
Loosen nut
-
Loosen nuts @.
-
Adjust the chain tension by turning adjusting screws (D
left and right.
Guideline
Chain tension
Turn adjusting screws (D on the left and right so that
the markings on the left and right chain adjusters are in
the same position relative to reference marks f). The
rear wheel is then correctly aligned.
-
Tighten nuts
Make sure that chain adjusters
adjusting screws (D.
-
Tighten nut
Guideline
Info
The wide adjustment range of the chain adjusters
(32 mm (1 .26 in)) enables different secondary
ratios with the same chain length.
Chain adjusters
Finishing work
- Remove the motorcycle from the lift stand.
Preparatory work
- Raise the motorcycle with a lift stand.
Main work
- Shift the transmission to idle.
- Check the rear sprocket and engine sprocket for wear.
If the rear sprocket and engine sprocket are worn:
- Change the drivetrain kit.
400227-01
O.
55 ... 58 mm (2.17 ...
1
2.28 in)
8.
are fitted correctly on
C,
0-
M20x1.5
can be turned by 180
C,
(� p. 14)
(!.;! p. 134)
Info
The engine sprocket, rear sprocket and chain
should always be replaced together.
14 WHEELS
80 Nm (59 lbf ft)
.
°
(� p. 14)
131