Husqvarna FE 450 2016 Repair Manual page 24

6 FORK, TRIPLE CLAMP
22
-
Clamp the fork leg with the axle clamp.
Release hydrostop unit
Info
Do not use an impact wrench.
Place a pan underneath since oil will run out.
Remove the cartridge from the fork leg.
Pressing tool (T14051)
Info
Removing the O-ring seat from the cartridge usually
requires the application of considerable force.
Remove dust boot (3.
Remove fork protector ring f).
Info
The fork protector ring does not necessarily need to
be removed for repair work.
Remove lock ring @.
Info
The lock ring has a beveled end where a screwdriver
can be applied.
-
Warm up the outer tube in area
ing.
1 Guideline
50 oc (122 OF)
Pull the outer tube from the inner tube with a jerk.
Info
Lower sliding bushing @ must be pulled from its
803528-13
bearing seat.
0
and remove it.
(� p. 368)
C,
of the lower sliding bush­