Husqvarna FE 450 2016 Repair Manual page 141

Remove shaft seal ring 6).
Using a suitable tool, press bearing
inside to the outside.
0.
Remove spacing tube
Using a suitable tool, press bearing (D out from the
inside to the outside.
Check spacer washer @ for damage and wear.
If the spacer washer is damaged or worn:
Replace the spacer washer.
Position spacer washer @.
Press new bearing (D all the way in from the outside to
the inside.
Info
Only press the bearing in via the outer ring oth­
erwise the bearing will be damaged when it is
pressed in.
-
Clean, grease, and mount spacing tube
1
Long-life grease (� p. 350)
C,
Press new bearing all the way in from the outside to
the inside.
Info
Only press the bearing in via the outer ring oth­
erwise the bearing will be damaged when it is
pressed in.
14 WHEELS
C,
out from the
0-
139