Table of Contents
Advertisement
14 WHEELS
110
Mount spacer O with washer.
'X V:
o 4m
D00794-10
Finishing work
-
Install the rear wheel. (Spi p. 104)
-
Remove the motorcycle from the lift stand. (81 p. 12)
-
Check the chain tension. ( p. 110)
Changing the rear brake disc
14.8,7
Preparatory work
-
Raise the motorcycle with a lift stand. (H p. 11)
-
Remove the rear wheel, (fil p. 104)
Main work
-
Remove screws O- Remove the brake disc.
-
Clean the contact surface of the brake disc.
-
Position the new brake disc with the label facing outward.
-
Mount and tighten screws O-
Guideline
1
4
V
, %-o
1
_w_
Uif
i
Loctite® 243™
Screw, rear brake disc
M6
14 Nm
(10.3 Ibf ft)
A
J
Finishing work
-
Install the rear wheel. (81 p. 104)
-
Remove the motorcycle from the lift stand. (81 p. 12)
-
Check the chain tension. (81 p. 110)
14.8.8
Checking the chain tension
Warning
Danger of accidents Incorrect chain tension damages components and results in accidents.
If the chain is tensioned too much, the chain, engine sprocket, rear sprocket, transmission and rear wheel bearings wear
more quickly. Some components may break if overloaded.
If the chain is too loose, the chain may fall off the engine sprocket or the rear sprocket. As a result, the rear wheel locks or
the engine will be damaged.
A
Check the chain tension regularly.
Set the chain tension in accordance with the specification.
Advertisement
Table of Contents
