Fuji Xerox ApeosPort Print C5570 Reference Manual page 281

Setting
Automatic line feed
Print instruction
CR Functions
Graphic dot quantity
Data size
HP-GL Mode
Hard Clip
Eject Command
Item No.
ESC PCL HP
- - -
- - -
61 - -
- - -
- - -
- - 150
- - 151
- - 152
(SP)
- - 153
(SP0)
- - 154
(NR)
- - 155
(FR)
- - 156
(PG)
- - 157
(AF)
- - 158
(AH)
Setting value
[0]: CR
[1] (Default): CR/LF
Note

Sets an auto line-feed operation when the right margin
position is exceeded.
 "CR" performs a carriage return only. "CR/LF" performs a
carriage return, and then a line feed.
[0] (Default): CR
[1]: All
Note
 [CR] sets the printing instruction command to CR only, [All]
sets the printing instruction command as CR, LF, VT, FF, US,
ESC a, and ESC b.
[0] (Default): Carriage return
[1]: New line
Note

This setting is not applied by extension commands sent
from users.
 Affects the print results of the 8-bit dot image printing
command.
[0] (Default): Native
[1]: Copy
[0]: 7 bit
[1] (Default): 8 bit
[0] (Default): HP-GL
[1]: HP-GL/2
Note
 Affects the IW, OW, and UC commands.

Configure "HP-GL/2" to print HP-GL/2 data without a BP
command.
[0]: Standard
[2] (Default): Paper
[0]: OFF
[1]: ON
Note
 Configure the command to indicate the end of drawing.
 If the command specified here is received, drawing is ended,
and the paper is output.

The default setting for SP0 is "ON" and "OFF" for other
commands.
 When multiple commands are specified, drawing is ended,
and the paper is output whenever any one of the commands
is received.
281
11.5 Emulation