Cleaning The Machine; Cleaning The Exterior Of The Machine; Cleaning The Interior (Led Printheads) - Fuji Xerox ApeosPort Print C5570 Reference Manual

8.5

Cleaning the Machine

WARNING
When cleaning this product, use the designated cleaning materials exclusive to it. Other cleaning

materials may result in poor performance of the product. Never use aerosol cleaners to avoid catching
fire and explosion.
CAUTION
When cleaning this product, always switch off and unplug it. Access to a live machine interior may cause

electric shock.
Important
 When working on the machine with the power turned off, check that the data LED is off before turning off the machine.
The print data and stored data in the memory are cleared when the machine is turned off.

Cleaning the Exterior of the Machine

Important
 Using volatile solvents such as benzine or thinner, or spraying with insecticide may cause discoloration, deformation, or
cracks on the covers or exterior.

Be aware that if the machine becomes too wet with water, it may malfunction or the original copy may be ripped during
printing.
1.
Wipe the exterior of the machine with a soft, moistened, and tightly-squeezed cloth.
Important
 Use only water or neutral detergent, and never use other solutions.
Note

When stains cannot be removed easily, wipe lightly with the soft cloth slightly moistened with a thin neutral detergent
solution.
2.
Wipe the moisture off with a dry soft cloth.

Cleaning the Interior (LED Printheads)

Usually, the LED print heads are cleaned at the same time as drum cartridge and waste toner container
replacement. However, clean the LED print heads when the image quality has been affected, such as when white or
colored stripes appear in prints.
1.
Make sure that the device is not operating, and open the front cover.
8.5 Cleaning the Machine
205