Connecting To A Computer With Usb; Connecting To A Wireless Network - Fuji Xerox ApeosPort Print C5570 Reference Manual

Connecting to a Computer with USB

1.
Press the <Power/Power Saver> button, and then select [Power Off Device] to turn off the power.
2.
Remove the rear right cover of the machine.
3.
Insert the USB cable into the USB connector (lower side) on the machine.
4.
Attach the rear right cover of the machine.
5.
Connect the other end of the USB cable to the computer.
6.
Press the <Power/Power Saver> button to turn on the machine.

Connecting to a Wireless Network

Before configuring the wireless LAN, check that the Wireless Network Kit (optional) is connected to this machine.
Refer

For more information, refer to "Installing the Wireless Network Kit" (P.229).
You can configure the settings for wireless LAN connection as follows.

"Connect with WPS (Push button method)" (P.24)

"Connect with WPS (PIN code method)" (P.25)

"Connect by selecting a wireless LAN access point from the list" (P.26)

"Connect by entering an SSID" (P.26)
Connect with WPS (Push button method)
Configure the setting on the control panel, and then press the WPS button on your access point or wireless router.
This method can be used if the wireless LAN access point supports WPS.
Refer
 For details on the WPS operation on the access point or wireless router, refer to the manual supplied with the access point
or wireless router.
24
2 Setting Up the Machine