Fuji Xerox ApeosPort Print C5570 Reference Manual page 275

Setting
Color Mode
Auto Layout
Palette Setup
Output quantity
Output destination
2 sided
Binding method for two-
sided printing
Paper Orientation
Page position
Note

Cannot be configured
when [Document
Size] is [Continuous
paper].
Item No.
ESC PCL HP
5 - -
- 216 -
- - 105
- - 106
- - 107
8 - 108
- 212 -
9 204 109
12 - 110
- 206 -
- 217 -
19 205 -
20 - -
Setting value
[0] (Default: ESC/P): Color
[0] (Default): Automatically Select
[1]: Color
[2]: Monochrome
[0] (Default): Color
[1]: Grayscale
[2]: Black pen
[0] (Default): ON
[1]: OFF
[0] (Default): Command
[1]: Panel
[1] to [250] (Default: 1): 1 to 250 copies
Note

If the machine receives a job from a client PC that specifies
the print quantity, that quantity will be applied for printing.
After the job is printed, the quantity set on the control panel
also becomes this value. However, the number of copies
specified from the lpd port does not change.
[1] to [999] (Default: 1): 1 to 999 copies
[0] (Default): Center tray (Lower)
[1]: Side tray (optional)
[2]: Center tray (Upper) (optional)
[80]: Finisher tray (optional)
[81]: Finisher output tray (optional)
[0] (Default): None
[1]: Long Edge Flip
[2]: Short Edge Flip
[0] (Default): Off
[1]: ON
[0] (Default): Long Edge Flip
[1]: Short Edge Flip
[0] (Default): Portrait
[1]: Landscape
[0] (Default): No cut sheet feeder (left)
[1] (initial value): Cut sheet feeder (center)
Note

If FF (form feed command) is received when there is no cut
sheet feeder, line feeding is performed by only the value
configured by VFU. When there is a cut sheet feeder, a form
feed is performed.
275
11.5 Emulation