[Connectivity & Network Setup] - Fuji Xerox ApeosPort Print C5570 Reference Manual

[SSL Cert Verification Failure]
Configure whether to stop access to the server or display an access confirmation screen when verification of the SSL
server certificate failed.
[Enable File Printing]
Configure whether to use the file print feature. With the file print feature, you can print printable files obtained from
an external Web server directly.
[Functional Code]
Configure as necessary when using a service linked to another machine.
[Remote Assistance Settings]
Configure the specifications related to Remote Assistance.
[Service Start Timeout]
Configure the upper limit of the service start wait time.
[Connectivity & Network Setup]
[Port Settings]
Note
 For LPD, Port 9100, and HTTP-SSL/TLS communication, do not use a number that is being used by another port.
For ports that use HTTP (IPP, Internet service (HTTP), UPnP discovery, SOAP, and Web Services on Devices (WSD)), do not
use the same numbers as the numbers of LPD, Port 9100, and HTTP-SSL/TSL communication.
In addition to the above, operation be no longer proceed normally due to port configuration conditions when the following
port numbers have been configured.
25, 139, 427, 445, 631, 15000
Refer
 For HTTP-SSL/TSL communication ports, refer to "[SSL/TLS Settings]" (P.132).
[USB]

[Port Status]
To use USB, configure to [Enabled].

[Print Mode]
Configure the type of print language to be used. If [Auto] is configured, the type of language in which the data
received from the host machine is written is determined automatically, and then printing is processed appropriately
to match the data.

[PJL]
A JCL (Job Control Language) command is data that has been added to the beginning of an actual print job. Use
typically with [Enabled] unchanged.

[Auto Eject Time]
Configure the time until paper is ejected automatically after data transmission to the machine has stopped.

[PostScript Wait Timeout]
Disconnect the connection automatically if data is not received for certain time at the machine. Configure [Adobe
Communication Protocol] to [RAW], and then configure the time until the connection is disconnected to
[Disabled] to follow [Auto Eject Time] or [Enabled] to follow the PostScript timeout.
121