Fuji Xerox ApeosPort Print C5570 Reference Manual page 199

Select the density distribution adjustment amount for the print sample from shapes 1 through 6.

[Level]
Select the level of density difference for the print sample from 1 through 6. Level 1 means that there is no
adjustment amount, and the adjustment amount increases as the value gets larger.

[Inboard / Outboard]
Adjust the density distribution with respect to the print sample as follows. Set the adjustment amount within the
range of -17 to 17.
The adjustment amount increases as the value gets larger.
Note

If the density distribution differs from these patterns, use [Shape] and [Level] to make adjustments.
10.
Tap [Save].
The adjustment value is applied.
11.
Tap [Density Uniformity Adjustment] > [Sample Printout], and then check the adjustment result of the output
sample. Adjust again if necessary.
Shape 1
Darker
Density
adjustment
amount
Lighter
IN
Shape 3
Darker
Density
adjustment
amount
Lighter
IN
Shape 5
Darker
Density
adjustment
amount
Lighter
IN
Input "+" value
Darker
Density
adjustment
amount
Lighter
IN
Shape 2
Darker
Density
adjustment
amount
Lighter
OUT IN
Shape 4
Darker
Density
adjustment
amount
Lighter
OUT IN
Shape 6
Darker
Density
adjustment
amount
Lighter
OUT IN
Input "-" value
Darker
Density
adjustment
amount
Lighter
OUT IN
OUT
OUT
OUT
OUT
8.2 Image Quality
199