Fuji Xerox ApeosPort Print C5570 Reference Manual page 276

Setting
Zoom Mode
Variable %/Vertical %
Variable %/Horizontal
%
Ruled Line
Font
Note
 This setting is not
applied by extension
commands sent from
users.
Alphanumeric font
276
11 Appendix
Item No.
ESC PCL HP
54 - -
17 - -
18 - -
22 - -
13 - -
14 - -
- - 112
Setting value
[0] (Default): Fixed %
[1]: Variable %
[2]: Whole output size
Note
 [Fixed %] uses a magnification calculated automatically
from [Document Size] and [Output Size] so that the
printable area of Document Size fits into that of Output Size.
Therefore, if the sizes specified for [Document Size] and
[Output Size] are the same, the document will be printed at
100% (actual size). In addition, when 2 Up is configured, 2
document-sized pages will be printed onto the printable
area of 1 page.

[Variable %] is a magnification specified by [Zoom] >
]Variable %]. The zoom reference value is in the upper left
of the printable area. This is the reference point for all text,
images, and graphics.
 The Whole Output Size area is printed on the printable area.
[Whole Output Size] uses a magnification calculated
automatically from [Document Size] and [Output Size] so
that the size of the physical paper of [Document Size] fits
into that of [Output Size].
 When continuous-form paper is selected for "Document
Size", "Fixed %" and "Whole Output Size" have the same
print result.
[45] to [210] (Default: 100): 45 to 210%
[0] (Default): Image
[1]: Font
Note
 Configure the method for printing for double-byte ruled line
font.
[3] (Default): ShuSong
[4]: FangSong
[5]: HeiTi
[6]: Writing Font
Note

This font is also applied to double-byte, half-width
characters.
 Configuration may not be possible depending on your
model.
[0] (Default): Roman
[1]: San serif
[0] (Default): Stroke
[0]: Roman
[2]: San serif