Fuji Xerox ApeosPort Print C5570 Reference Manual page 57

3)
Unscrew the screw of the front guide and remove the guide from the tray.
4)
Insert the small protrusions at the bottom of the guide into the holes corresponding to the paper size (1),
insert the protrusion on the tray into a hole corresponding to the paper size on the top of the guide, and
then tighten the screw (2).
(1)
5)
As shown in the diagram, pull up the lever of the end guide (1). While moving the lever along the slot, set it
at the position corresponding to the paper size (2), and then press the lever down (3).
Note

The groove to the left of 8.5" of the end guide is not used.
4.
Open the end guide. Load the paper with the print side facing down and its leading edge aligned with the right
side of the paper tray.
(1)
(3)
(2)
(2)
3.5 Loading Paper
57