Wi-Fi Direct Connection Troubles; Ipv6 Connection Problems - Fuji Xerox ApeosPort Print C5570 Reference Manual

Cannot connect to wireless LAN using WPS-
PIN (PIN code method)
Cannot set the network mode on the
machine to Ad-hoc mode.

Wi-Fi Direct Connection Troubles

Cannot find the machine from a mobile
device.
Cannot connect the machine with a mobile
device.
Cannot disconnect a mobile device from the
machine.
Cannot enable the [Wi-Fi Direct] setting.

IPv6 Connection Problems

The machine cannot be accessed when
specifying a link-local address
The machine cannot communicate with
Windows operating systems that van use
IPv6.
The Secure Watermark feature does not
properly function when printing over an
IPv6 network
Cannot find an IPv6 device under UPnP
Authentication fails if a computer name is
specified in the SMB server settings of SMB
authentication in an IPv6 network
environment that does not have a DNS
server.
Symptom
Symptom
Symptom
Check if the PIN code entered in the wireless LAN access point is
correct.
Refer
 For details on how to input a PIN code, refer to the manual provided
with the wireless LAN access point.
The mode cannot be set if the Wi-Fi Direct port is active.
The machine may be connected with other mobile device via Wi-Fi
Direct. Terminate the connection with other mobile device.
When you are connecting to this machine using the Wi-Fi Direct
feature of an Android device, configure [Group Settings] to [Group
Owner] on this machine, and then check again.
Refer

For details, refer to "Group settings" (P.93).
A mobile device automatically reconnect with the machine.
Either change the passphrase of Wi-Fi Direct or disconnect at the
mobile device.
Check if the network mode is set to infrastructure mode.
Make sure that [IP Mode] is configured to a mode other than [IPv6
Mode].
Add a scope identifier to the link-local address.
For example, when using Windows to specify
fe80::203:baff:fe48:9010 for access, add an Ethernet adapter local
area connection number (8, for example) as the scope ID, and
enter: fe80::203:baff:fe48:9010%8.
Configure a fixed address with a Windows OS that can use IPv6.
Register the configured fixed IPv6 address on the machine as a
communication-enabled host address.
Run under an IPv4 environment.
The Secure Watermark feature does not work in an IPv6
environment.
In an IPv6 environment, use the Web Services on Devices (WSD)
discovery function.
Directly specify an IPv6 address for the computer name in the
authentication server parameters.
Cause/Remedy
Cause/Remedy
Cause/Remedy
9.6 Network-related Problem
225