Replacing Booklet Staples (When C3 Finisher With Booklet Maker Is Installed) - Fuji Xerox ApeosPort Print C5570 Reference Manual

3.
While holding the tabs on both sides of the new booklet staple cartridge, install it in the original position, push
lightly from the top, and make sure that it clicks into place.
4.
Exchange the other one in the same manner.
5.
Close the finisher side cover.
Replacing booklet staples (when C3 Finisher with Booklet
Maker is installed)
A message appears on the touch panel display according to the remaining amount of staples.
Note

Before replacing the booklet staple cartridge, tap [Device] > [Supplies] on the Home screen and check the status of the
booklet staple cartridge.
1.
Make sure that the device is not operating, and open the finisher front cover.
2.
Pull out the booklet unit.
184
8 Maintenance