Fuji Xerox ApeosPort Print C5570 Reference Manual page 122


[Adobe Communication Protocol]

[Standard]
Configure when the output protocol of the printer driver is ASCII format.

[Binary]
Configure when the output protocol of the printer driver is BCP format.

[TBCP]
Configure when the output protocol of the printer driver is TBCP format.

[RAW]
Configure when the output protocol of the printer driver is ASCII format or binary format.
The data is output as is without any restrictions of the Adobe communication protocol.
[LPD]

[Port Status]
To use LPD, configure to [Enabled].

[Port Number]
Configure the port number of LPD.
Note

Do not use a number that is being used by another port.

[Maximum Number of Sessions]
Configure the maximum number of clients that can connect simultaneously by LPD to this machine.
[IPP]

[Port Status]
To use IPP, configure to [Enabled].
Configure when using IPP to print via the Internet.

[Added Port Number]
Configure whether to receive IPP by a non-standard port.
Note

Do not use a port number that is already being used by another port. However, the same port numbers as the ports that
use HTTP (Internet service (HTTP), UPnP discovery, SOAP, and Web Services on Devices (WSD)) can be used.
 [Added Port Number] cannot be configured when [Port Status] is [Disabled]. Configure [Port Status] to [Enabled], press
the <Home> button, and then tap [Restart Now]. After this machine restarts, configure [Added Port Number].
[Bonjour]

[Port Status]
To use Bonjour, configure to [Enabled].
Note
 To use Bonjour and print using a detected printer, the LPD port must be started in advance.
[Port 9100]

[Port Status]
To use Port9100, configure to [Enabled].
Configure when the Raw protocol is used with Windows standard TCP/IP port monitoring.
122
6 Changing the Machine Settings