Fuji Xerox ApeosPort Print C5570 Reference Manual page 106


When the [Condensation Alert] box is checked, a message is displayed when the machine detects that dew
condensation may have occurred.
Note
 The machine does not enter Sleep Mode during warm-up mode operation.
[Print-On-Demand Duration]
Configure the effective time when printing using external access. If print data is not received from the external
connection destination during the time configured here after a print command, print instructions become invalid.
Note

When print instructions for a large volume of documents were issued at once, or when complex documents that require
time to process are included, a timeout may occur before receiving the final page.
[Power Saver Settings]
[Power Saver Timers]
There are two Power Saver Modes: "Low Power Mode" and "Sleep Mode". If the configured time passes after this
machine was last used, the machine enters the following modes to lower power consumption.
Note
 The machine cannot be configured not to enter Low Power Mode and Sleep Mode.
 Configure the settings so that the time to enter Sleep Mode is either the same or greater than the time to enter Low
Power Mode.

When the times are the same, the machine enters Sleep Mode, not Low Power Mode.
[Enter Power Saver]
Configure the timing to enter Power Saver Mode after printing is completed from a computer.
[Sleep Mode Settings]
Configure whether to prioritize power savings or recovery time for operations during Sleep Mode.
[Power Saver Deactivation]
Configure whether to exit only the section to be used when exiting Power Saver mode.
[Scheduled Power Off]
Configure whether turn off the machine at the configured time.
Note

The machine does not turn off when a paper jam or other problem is occurring at the machine, or when jobs,
interruptions, and other processing is occurring, even when [Enabled] is configured.
[Audio Tones]
Configure the notification sounds for the end of jobs, machine errors, etc.
[Screen Settings]
[Screen Default]
Configure the screen to be displayed when turning on the power or exiting Power Save mode.
[Default Language]
Configure the language to be displayed when the power is turned on.
106
6 Changing the Machine Settings