Error Code List - Panasonic GM1 User Manual

9.9 Error Notification Function
1.
Turn the controller OFF and then ON.
If the problem persists, consult your Panasonic representative.

9.9.5 Error Code List

Error Operatio
No. n
0x0001 Stop
0x0002 Stop
0x0003 Continue System error
0x0106 Continue Device date
0x0110 Continue PWM
to 0x113
0x0120 Continue PWM
to 0x123
0x0130 Stop
to 0x131
0x0140 Stop
to 0x141
0x0150 Continue Counter
to 0x151
0x0160 Continue Counter
to 0x161
0x0170 Continue Counter
to 0x171
0x0200 Continue Expansion unit An expansion unit communication error has occurred. Check
9-40
Name Error description and action method
System error Notify us of the error information or system data history
(serious) information displayed on the status window of GM
Programmer.
System error Notify us of the error information or system data history
(CODESYS) information displayed on the status window of GM
Programmer.
Notify us of the error information or system data history
(minor) information displayed on the status window of GM
Programmer.
Because the duration of the power failure exceeded the
and time, RTC guaranteed period (14 days), the RTC time information was
error initialized.
The device must be left ON for at least 10 minutes. (Time
information is reset to April 1, 2019.)
The cycle setting is out of range. Check whether the duty
ratio is within the allowable range.
Frequency
setting error
The duty ratio setting is out of range. Check whether the
duty ratio is within the allowable range.
Duty ratio
setting error
Counter The counter value exceeds the upper limit. Perform reset or
preset operation so that the counter value falls within the
Overflow error
range between the upper and lower limits.
Counter The counter value drops below the lower limit. Perform reset
or preset operation so that the counter value falls within the
Underflow
range between the upper and lower limits.
error
The count value becomes 0 under the reset conditions and
goes out of the range between the upper and lower limits.
Reset
Check the settings of the upper and lower limits of the
abnormal error
counter. If 0 does not exist in the range between the upper
and lower limits, make a preset request.
The count value goes out of the range between the upper
and lower limits under the preset conditions. Check whether
Preset
the preset value falls within the range between the upper
abnormal error
and lower limits.
The count value goes out of the range between the upper
and lower limits when the current value is changed. After the
Current value
current value is changed, check whether the new value falls
change
within the range between the upper and lower limits.
abnormal error
connections.
Recover
y
method
Power
cycle
Power
cycle
Power
cycle
Clear the
error
Re-
downloa
d
Re-
downloa
d
Re-
downloa
d
Re-
downloa
d
Re-
downloa
d
Re-
downloa
d
Re-
downloa
d
Clear the
error
WUME-GM1RTXOP-01