11.5 Multi-axis Operation
Start interpolation control operation using the starting coordinates specified in the window.
● If the specified starting coordinates differ from the operation starting coordinates, there is a
risk that rapid movement may occur.
11.5.12 Interpolation Operation Programming: P-point Control and C-point
Control
When composite interpolation operations are executed by the GM1 controller, continuity
between interpolated movements becomes an issue.
The GM1 controller supports C-point control from the following two types of control.
■
P-point control
P-point control refers to control passing through a "Pass Point". In this manual, this control is
referred to as "P-point control" for the sake of convenience.
11-88
WUME-GM1RTXOP-01