1.
Click the "Copy" icon on the toolbar.
The Copy Parameter window will be displayed.
2.
In the "Copy source" area, select an axis from which parameters are to be copied.
3.
In the "Copy destination" area, select an axis to which parameters are to be copied.
4.
Click the [OK] button.
5.
The Parameter window for the copy destination axis will be displayed.
6.
Click the "Trans" icon on the toolbar.
The parameters will be written to the servo amplifier.
7.
Click the [EEP] icon on the toolbar.
WUME-GM1RTXOP-01
15.7 Parameter Window
15-27