Error Code Table; System Error (From 1000H) - Panasonic FP7 User Manual

Errors and Warnings

15.3 Error Code Table

15.3.1 System Error (from 1000H)

These are the errors that occur due to any failure within the positioning unit. The system
errors are defined as fatal errors for the system. Except for some items, the power supply
must be turned off and on again to recover from the errors.
Error
Error name
code
System
1000H
runaway
Hardware
1001H
error
1002H Unit error
System
1003H processing
error
Tool
operation
1020H
abnormal
end
CPU unit
1030H
error
CPU unit
1031H operation
mode error
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com 15-6
Description
System runaway
If the error occurs, the ALARM LED
on the positioning unit will be lit.
An error has occurred in a hardware
test with the power supply turned on.
Any error has occurred in the internal
processing.
An error has occurred in the system
processing due to some reason.
An error in communication with the
PC has occurred while operating the
programming tool with the positioning
setting menu.
An alarm has occurred to the CPU
unit.
The system in operation has come to
a stop because the CPU unit is
switched to PROG. Mode.
Object Recovered
All
No
Turn off the power supply and
axes
turn it on again.
All If an error occurs repeatedly,
No
axes consult your Panasonic
representative.
All
No
axes
Check the settings.
If an error occurs repeatedly
All
Yes
with the correct set values,
axes
consult your Panasonic
representative.
Check the connection of the
cable connecting the PC and
All
Yes
PLC.
axes
Reboot the PC.
Check the condition of the
CPU unit.
All
No
axes
Turn off the power supply and
turn it on again.
Check the condition of the
CPU unit.
All
Yes
axes
Set the CPU unit to PROG.
Mode.
Countermeasures