Panasonic GM1 User Manual page 497

● Enable count operation is used by allocating the enable function to the control flag. Count
operation is performed while the control flag is enabled.
● Enable count operation can be set using the methods shown in the following table.
Types of control flag (enable processing)
Signal
Count enable
request bit
Control 0 signal
Control 1 signal
(Note 1) If you set the control 0 signal or control 1 signal as the enable operation condition, do not use the
count enable request bit.
Count enable operation example
■
Reset count operation
● Reset count operation is used by allocating the reset function to the control flag.
● The count value is reset to 0 according to the change (rising, falling, positive logic, or
negative logic) of the control flag.
● Reset count operation can be set using the methods shown in the following table.
Types of control flag (reset processing)
Setting method using the
Signal
Counter_Configuration parameters
Reset request
- (No need to set)
bit
WUME-GM1RTXOP-01
Setting method using the Counter_Configuration parameters
- (No need to set)
Setting the enable operation conditions by setting up the control 0
signal function
Setting the enable operation conditions by setting up the control 1
signal function
12.6 High-speed Counter Function
Reset condition
●
Enable condition
●
● ●
● ●
12-35