Panasonic GM1 User Manual page 499
Motion controller controller rtex
Hide thumbs
Also See for GM1:
- Reference manual (166 pages) ,
- User manual (138 pages) ,
- Reference manual (98 pages)
Table of Contents
Advertisement
Reset (preset) count operation example
■
Enable reset count operation
● Enable reset count operation is used by allocating the enable function and reset function to
the control flag.
● The count value is reset to zero when the counter becomes enabled due to the change of the
control flag (enable reset processing).
Types of control flag (enable reset processing)
Setting method using the
Signal
Counter_Configuration parameters
Control 0
Setting the following conditions by setting up the
signal
control 0 signal function
Positive logic enable operation and reset
operation at rising edge
Negative logic enable operation and reset
operation at falling edge
■
Enable preset count operation
● Enable preset count operation is used by allocating the enable function and preset function
to the control flag.
● The count value is set as a preset value when the counter becomes enabled due to the
change of the control flag (enable preset processing).
Types of control flag (enable preset processing)
Setting method using the
Signal
Counter_Configuration parameters
Control 0
Setting the following conditions by setting up the
signal
control 0 signal function
Positive logic enable operation and preset
operation at rising edge
Negative logic enable operation and preset
operation at falling edge
WUME-GM1RTXOP-01
12.6 High-speed Counter Function
Reset condition
●
●
Preset condition
●
●
Enable condition
●
●
Enable condition
●
●
12-37
Advertisement
Table of Contents
