Panasonic GM1 User Manual page 44

3.4 Component Names
Item
Debug
Item
Start
Stop
Single Cycle
New Breakpoint
Edit Breakpoint
Toggle Breakpoint
Disable Breakpoint
Enable Breakpoint
Step Over
Step Into
Step Out
Run to Cursor
Set next Statement
Show next Statement
Write Values
Force Values
Unforce Values
Toggle Flow Control Mode
Display Mode
3-16
Function
Item Function
Debug Allows all debug operations to be executed.
Prohibits some operations such as adding
Locked
new breakpoints or forcing variable values.
Prohibits any changes other than writing
Operational
variables.
Function
Starts the application.
Stops the application.
Executes the application in every single cycle.
Creates a new breakpoint.
Allows the user to edit breakpoints.
Allows the user to set or delete breakpoints.
Disables invalid breakpoints.
Enables valid breakpoints.
Executes the program line by line. When a block (function or
function block) is executed in the block invocation location, the
cursor moves to the next line.
Executes the program line by line. When a block (function or
function block) is executed in the block invocation location, the
cursor moves to the first line of the called block.
When the program is executed within the called block, the execution
continues until control returns to the calling block. When the
program is executed outside the called block, the execution
continues until control returns to the beginning of the program.
Executes the program up to the line specified by the cursor.
Regards the line specified by the cursor as the next statement to be
executed and skips processes over to that line.
Jumps the cursor to the program line to be executed as the next
step.
Sets a value (to be changed later) only once. This value can then be
changed by the program.
Sets a value to be changed in every cycle and maintains the value.
Cancels forced value change
Performs monitoring by using different colors in positions where the
program is executed and in positions where the program is not
executed.
Allows the user to select binary, decimal, or hexadecimal as the
display format of the variable value to be displayed.
WUME-GM1RTXOP-01