Setting Up The Servo Amplifier Connected To The Gm1 Controller - Panasonic GM1 User Manual
Motion controller controller rtex
Hide thumbs
Also See for GM1:
- Reference manual (166 pages) ,
- User manual (138 pages) ,
- Reference manual (98 pages)
Table of Contents
Advertisement
The following parameters will be changed: "Absolute encoder setting", "Number of output
pulses per motor revolution", "RTEX communication cycle setting", and "RTEX command
update cycle ratio setting".
4.
Click the [OK] button.
The "Setting Complete" dialog box will be displayed.
5.
Click the [OK] button.
The main pane will be displayed. Start the servo amplifier.
15.6.2 Setting up the Servo Amplifier Connected to the GM1 Controller
The PC communicates with the servo amplifier connected to the GM1 Controller.
Connect the PC and GM1 Controller with a USB cable or Ethernet cable. With the GM1
Controller and servo amplifier connected with a Cat5e shielded cable, set up the servo
amplifier.
Make this setting only after the connection between the GM1 Controller and the servo
amplifier has been established.
When Connected Using the Ethernet Cable
If connected using the Ethernet cable, use the following procedure.
1.
Start PANATERM Lite for GM.
The "Connect" dialog box will be displayed.
WUME-GM1RTXOP-01
15.6 Selecting the Device to Connect
15-17
Advertisement
Table of Contents
