Konica Minolta REGIUS 190 Service Manual page 89

2.4 Transport Unit
•
Remarks for Installation
Confirm that the bracket-press springs (vertical) are securely
fitted on the guide shafts for upper and lower brackets. If the fit-
ting is not correctly installed, the bracket-press spring may
interfere each other when the Transport Unit comes to the mag-
netizing point, and cause a trouble in operation.
Before fixing the screw for the receiver motor bracket, confirm
that the top edge of the guide shaft is correctly fitted into the
hole of the receiver motor bracket.
When attaching the tie band to the wires on the receiver sensor
bracket, fit it into the groove with its end shown in the right.
62
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Blacket-Press Spring (Vertical)
Note : Must properly fit on the guide shaft.
Fixing Screw
Receive Motor Braket
Confirm that the top edge of
the guide shaft is correctly
fitted into the hole of the
receiver motor bracket.
Tie Band
Groove