Replacement Of Sup3(Halogen Power Supply) - Konica Minolta REGIUS 190 Service Manual

2.7 Electrical Unit
2.7.7

Replacement of SUP3(Halogen Power Supply)

1.
Remove the rear cover. (See
2.
Remove two fixing screws, and remove the cover for the
SUP3 (halogen power supply).
3.
Unplug three connectors from the SUP 3 (halogen power
supply).
• JP8, JP9, JP11
4.
Remove 4 fixing screws, and remove the SUP 3 (halogen
power supply).
5.
Carry out reassembly in the reverse order to that described
above.
•
Remarks for installation
When it is replaced with a new SUP3, check the voltage at the
following point is DC 24V using a digital multi meter.
• DC 24V: Between SUP3 JP11 / PIN 1 (24V) - PIN 5
(GND)
p.28 )
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Fixing Screws SUP3 (halogen power supply)
89