Konica Minolta REGIUS 190 Service Manual page 145

3.6 Adjusting the Peel-Detection Rollers
The peel detection mechanism is laterally symmetric. In this paragraph, explanation is made for the left mecha-
nism.
No Part
1 Peel Detect Roller
2 Peel Detect Arm-L
3 Peel Detect Cam-L
4 Peel Detect Sensor-L
5 Peel Detect Sensor
Plate-L
6 Peel Detect Adjuster
Plate
118
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01
Name Function
When a back plate (Plate) of a thickness greater than specification is ascending,
it touches the peel detect roller and press it toward the front of the device. When
a plate of standard thickness ascends, it will not touch the peel detect roller.
Because the roller rotates even in contact with the plate, it will not block the
plate to ascend further.
GOOD
Magnetizing Back Plate +
Plate REGIUS Plate
Sustains the peel detect roller (1) from the left. As the peel detect roller (1) is
pressed, rotates around the axis "A" accordingly. Sensor plunger will start
ascending as it starts rotation.
Move the position of this sheet plate to adjust the reference position of the peel
detect roller (1).
• When the sensor plunger of the peel detect arm-L (2) ascends and sepa-
rates, it switches to "ON", and detects the peeling or warping of the plate.
• As this sensor switches from "OFF" to "ON", the subscanning operation will
immediately stop, and the cassette magnetization plate will descends to the
subscan HP.
Metal plate to which the peel detect sensor-L (4) is mounted. the position of peel
detect sensor-L (4) can be adjusted up and down around the shaft "B" in the
center.
Metal plate to make a fine adjustment of the peel detect sensor plates-L(5) in
vertical direction. Peel detect screw to push the peel detect sensor plate-L (5)
up and hexagonal nut to secure the screw is attached to this metal plate.
NG
Peel Detect Roller