Konica Minolta REGIUS 190 Service Manual page 75

2.3 Insertion / Ejection Unit
Ejection senor bracket (step4.)
Fix the screws while the eject sensor bracket is held up.
Detector Pin
Confirm that the sensor pin stays close to the center of the
Eject. Sensor
ejection sensor when the ejection shutter closes.
Ejection sensor wiring guide plate(step3.)
Confirm that the sensor wires are not sandwiched by the plate,
then tighten the screws.
Eject. Sensor Bracket
Fixing Screws
48
REGIUS MODEL 190 Service Manual Ver.1.00 2004.11.01